ap-ip
Wireless configuration commands
Modifies the static IP address for an access point
Supported in the following platforms:
•
•
•
Syntax
Parameters
ap-ip <AP-list/MAC>
[static-ip|controller-ip]
default-ap controller-ip [
add <IP-list>|
delete [<IP-index>|<IP>]|
set-default]
Example
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Mobility RFS4000 Controller
Mobility RFS6000 Controller
Mobility RFS7000 Controller
ap-ip [<AP-list/MAC>|default-ap]
ap-ip <AP-list/MAC> [static-ip|controller-ip]
ap-ip <AP-list/MAC> static-ip <IP/Mask> <gateway-IP>
ap-ip <AP-list/MAC> controller-ip [add <IP>|
delete [<IP>|<IP-index>]|<IP>|set-default]
ap-ip default-ap controller-ip [add <IP address>|delete [<IP|<IP-index>]|
<IP address>)|set-default]
Use show wireless ap to view an AP's index or MAC address.
Select the AP's index / MAC Address to modify its static IP
address.
•
•
Sets the default static controller IP address
•
RFController(config-wireless)#ap-ip 1 static-ip 192.168.10.25/24 192.168.10.1
RFController(config-wireless)#
RFController(config-wireless)#ap-ip 1 controller-ip add 192.168.10.25
10.10.1.4
Wireless configuration commands
static-ip <IP/Mask> <gateway-IP> – Sets the static IP
address, netmask and gateway address of the AP
•
<IP/Mask> – Defines the static IP address and mask
•
<gateway-IP>– Sets the gateway IP address
controller-ip [add <IP>| delete
[<IP>|<IP-index>]|<IP>|set-default] – Defines the static
controller IP address
•
add <IP> – Adds a static controller IP address <IP>
•
delete [<IP-index>|<IP>] – Deletes a static controller IP
address
•
<IP-index> – A single controller IP address in the
range 1-12.
•
<IP> – A single IP address
•
set-default – Default controller IP address
controller-ip – Static controller IP address
•
add – Adds a static controller IP address
•
delete[<IP-index>|<IP>] – Deletes a static controller IP
address
•
<IP-index> – A single controller IP address
•
<IP> – A single IP address
•
set-default – Sets a default controller IP address
20
605