ap-detection
Wireless configuration commands
Configures access point detection parameters
Supported in the following platforms:
•
•
•
Syntax
Parameters
approved add
<list-index>
[<MAC>|any]
enable
client-assisted-scan
[enable|
refresh <refresh-period>]
ap-detection timeout
[approved|unapproved]
<timeout>
Example
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Mobility RFS4000 Controller
Mobility RFS6000 Controller
Mobility RFS7000 Controller
ap-detection [add|detect-wired-rouge|enable| mu-assisted-scan|timeout]
ap-detection
add <list-index>[authorized|ignored] [<MAC>|any] <LINE>|any]
ap-detection detect-wired-rouge enable
ap-detection enable
ap-detection mu-assisted-scan [enable|refresh <refresh-period>]
ap-detection timeout [authorized|unauthorized|ignored] <timeout>
Sets the approved access point list
•
•
•
Allows access points to look for APs
Sets wireless client assisted scanning configuration
•
•
Sets the amount of time (in seconds ) an AP remains in the list
after it is no longer seen
•
•
RFController(config-wireless)#ap-detection enable
RFController(config-wireless)#
RFController(config-wireless)#ap-detection authorized add 150 any any
RFController(config-wireless)#
RFController(config-wireless)#ap-detection client-assisted-scan enable
RFController(config-wireless)#
RFController(config-wireless)#ap-detection client-assisted-scan refresh 520
RFController(config-wireless)#
Wireless configuration commands
add <list-index> – Adds an entry to the approved access
point list at the index <list-index>.
<MAC> – The a MAC address <MAC> in AA-BB-CC-DD-EE-FF
format.
any– Assigns any MAC address.
enable – Enables wireless client assisted scanning
refresh <refresh-period>> – Defines the period
<refresh-period> (300 – 86400) (in seconds) used by all
scan-capable wireless clients are polled to scan for
neighboring access points.
approved <timeout> – The timeout <timeout> in seconds for
approved APs.
unapproved <timeout> – The timeout <timeout> in seconds
for unapproved APs
20
603