Common Commands
In this chapter
This chapter describes the CLI commands used in the USER EXEC, PRIV EXEC, and GLOBAL
CONFIG modes.
The PRIV EXEC command set contains those commands available within the USER EXEC mode.
Some commands can be entered in either mode. Commands entered in either USER EXEC mode or
PRIV EXEC mode are referred to as EXEC mode commands. If a user or privilege is not specified,
the referenced command can be entered in either mode.
Common commands
Table 2.1
Command
clrscr
exit
help
no
service
show
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
•
Common commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
•
show . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 59
summarizes available common commands:
Table 2.1 Common Commands in RFController
Description
Clears the display screen
Ends the current mode and moves to the previous mode
Displays the interactive help system
Negates a command or sets its defaults
Services or debugs the controller
Shows running system information
Chapter
2
Ref.
page 32
page 33
page 34
page 35
page 37
page 59
31