Deny - Brocade Communications Systems RFS4000 Cli Reference Manual

deny

MAC Extended ACL config commands
Specifies packets to reject
NOTE
Use a decimal value representation of ethertypes to implement a
for a packet. The command set for Extended MAC ACLs provide the hexadecimal values for each
listed ethertype. The controller supports all ethertypes. Use the decimal equivalent of the ethertype
listed for any other ethertype.
Supported in the following platforms:
•
•
•
Syntax
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Mobility RFS4000 Controller
Mobility RFS6000 Controller
Mobility RFS7000 Controller
deny [<MAC/Mask>|any|host <MAC>] [<MAC/Mask>|any|
host <MAC>] {[dot1p|rule-precedence|type|vlan]}
deny [<MAC/Mask>|any|host <MAC>] [<MAC/Mask>|any|
host <MAC>] dot1p <0-7> {rule-precedence|type}
deny [<MAC/Mask>|any|host <MAC>] [<MAC/Mask>|any|
host <MAC>] rule-precedence <1-5000>
deny [<MAC/Mask>|any|host <MAC>] [<MAC/Mask>|any|
host <MAC>] type [8021p|<1-65535>|aarp|appletalk|apr|ip|
ipv6|ipx|rarp|wisp] {rule-precedence <precedence>}
deny [<MAC/Mask>|any|host <MAC>] [<MAC/Mask>|any|
host <MAC>] vlan <1-4094> {rule-precedence|type}
MAC Extended ACL config commands
permit/deny/mark
16
designation
489