20
Wireless configuration commands
1. Use
2. Specify the VLAN over which the sensors are available. This will help the controller detect
3. Use
NOTE
To convert multiple APs' to Sensor, do it one by one and do config modifications.
618
command to setup the sensor.
sensor
RFController(config-wireless)#sensor default-config ?
ip-mode
configure the IP address mode of the sensors
wips-server-ip
specify IP addresses of the WIPS server
Select either
ip-mode
them.
RFController(config-wireless)#sensor vlan 10
command to convert the selected AP into a sensor directly from the controller.
convert-ap
RFController(config-wireless)#convert-ap 1 sensor
or
wips-server-ip
as the sensor parameter.
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01