Brocade Communications Systems RFS4000 Cli Reference Manual page 650

20
Wireless configuration commands
Parameters
<1-4096>
<radio-list>
add <1-4096> <MAC>
[11a|11an|11b|11bg|
11bgn] [br5181|br300|
br7131]}
all-11a
all-11an
all-11b
all-11bg
all-11bgn
antenna-mode
[diversity|mimo|primary|
secondary]
configure-8021X
default-11a
default-11an
default-11b
default-11bg
default-11bgn
dns-name <WORD>
<AA-BB-CC-DD-EE-FF>
lldp [hold-time|mode|
refresh-interval]
648
Defines a single radio index.
Creates a list (1,3,7) or range (3-7) of radio indices.
Adds the specified radio to the radio list at index specified for the
value in the range 1-4096.
•
[11a|11an|11b|11bg|11bgn] – The radio type
•
[br5181|br300|br7131] – Optional. The radio model. The
options available will depend on the radio type selected.
All 11a radios currently in configuration
All 11an radios currently in configuration
All 11b radios currently in configuration
All 11bg radios currently in configuration
All 11bgn radios currently in configuration
Antenna diversity mode. Select diversity from:
•
diversity – Use full diversity (both antennas)
•
mimo – use MIMO
•
primary – Use primary antenna only
•
secondary – Use secondary antenna only
Configures the 802.1X username and password on adopted
access points
Adopts the default 11a configuration template
Adopts the default 11an configuration template
Adopts the default 11b configuration template
Adopts the default 11bg configuration template
Adopts the default 11bgn configuration template
Configures dns-name to be used in L3-Discovery on adopted
access-points.
•
<WORD> - Specify the dns-name the access-ports must use
(upto 127 characters)
•
<AA-BB-CC-DD-EE-FF> - Change the dns-name only on
the access-point with a specified MAC address. If not
specified, the dns-name update is sent to all currently
adopted access-points
Displays the commands related to LLDP advertisements.
•
hold-time <4-10>– Sets the HoldTime Multiplier value on
LCAP. The default value is 4.
•
<4-10> – Specifies the range of the HoldTime Multiplier
value in seconds.
•
mode – Sets the LLDP status on LCAP.
•
disable – Disables the LLDP advertisements.
•
refresh-interval <30-32768> – Sets the LLDP refresh
interval on LCAP. This parameter indicates the interval at
which LLDP frames are transmitted on behalf of the LLDP
agent.
•
<30-32768> – Specifies the range of Refresh Interval
Value in seconds.
NOTE: By default, the LLDP mode is disabled.
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01