Port-Channel - Brocade Communications Systems RFS4000 Cli Reference Manual

12
Interface config commands

port-channel

Interface config commands
Selects the load-balance criteria of an aggregated port
Supported in the following platforms:
•
•
NOTE
This command is not supported on the Mobility RFS6000 Controller.
Syntax
Parameters
load-balance
[src-dst-ip|src-dst-mac]
Usage Guidelines
Use this command to configure and set load balance on the aggregated port using
static-channel-group
Example
The following example creates a channel group 1, with interface ge1 and ge 2:
The following example defines the load balance based on the IP or MAC address:
Configuring a port aggregation
Use
below to configure port aggregation:
1. Create a static channel group for port aggregation and associate an interface with it.
2. Execute
418
Mobility RFS7000 Controller
Mobility RFS4000 Controller
port-channel load-balance [src-dst-ip|src-dst-mac]
Sets load-balancing for port channel
•
•
.
RFController(config)#interface ge1
RFController(config-if)#static-channel-group 1
RFController(config)#interface ge2
RFController(config-if)#static-channel-group 1
RFController(config)#interface sa1
RFController(config-if)#port-channel load-balance src--dst-ip
RFController(config-if)#
and
static-channel-group
RFController(config)#interface ge 1
RFController(config-if)#static-channel-group 1
show static-channel-group
sa 1 has been created and associated with
src-dst-ip – Defines the Source and Destination IP address
based on the current load balancing
src-dst-mac – Sets the Source and Destination MAC
address based on the load balancing
for configuring port aggregation. Follow the steps
port-channel
and ensure the virtual static aggregation
ge 1.
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
(config-if)
53-1001931-01