20
Wireless configuration commands
Usage Guidelines
Use
LIST) to the default shared secret. It is saved in the running configuration file.
Use
LIST). The AP's MAC, and mode will be saved in the running configuration.
Use
(specified by LIST). The AP's MAC, and staging mode will be saved in the running configuration. In
this mode, controller will not send at all configured shared secret in the Join response to the AP
and AP will not get adopted by the controller.
600
<LIST>
[ABG-Scan|aap-admin-pass
wd|aap-log-storage|aap-sysl
og-srvr|adoption-policy|
country-code|
location|leds|
name|secure-code|
secure-mode-stagging|aap-i
pfilter-list |
aap-lan1-ipf-rules|aap-lan1-t
runking]
<MAC-address>
[ABD-Scan|aap-admin-pass
wd|aap-log-storage|aap-sysl
og-srvr|adoption-policy|
country-code
|location|ledsl|
name|radio-config|
secure-code|
secure-mode-stagging|aap-i
pfilter-list |
aap-lan1-ipf-rules|aap-lan1-t
runking]
{no} ap <LIST> secure-mode secret
{no} ap <list> secure-mode enable
{no} ap <list> secure-mode-staging enable
•
aap-lan1-trunking [disable|enable] – Configures trunking on
LAN1 of AAP
•
disable – Disables trunking on AAP LAN 1 inerface
•
enable mgt-valn-id – Enables trunking on AAP LAN
1 inerface
•
mgmt-vlan-id <1-4094> native -vlan-id –
Configures management VLAN ID on AAP between
1 and 4094
•
native-vlan-id <1-4094> native-tagging –
Configures native VLAN ID on AAP between 1 and
4094
•
native-tagging [tagged|untagged] – Configures
native VLAN tagging on AAP between 1 and 4094
•
tagged – Enables native VLAN tagging on AAP LAN
1 inerface
•
untagged – Disables native VLAN tagging on AAP LAN 1
inerface
A list (eg: 1,3,7) or range (eg: 3-7) of AP indices from the
command
wireless ap
Lists an AP's MAC address.
to reset a shared secret for a set of APs (specified by
to disable secure-mode to a set of APs (specified by
to disable secure-mode staging to a set of APs
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
show
53-1001931-01