In This Chapter; User Exec Commands - Brocade Communications Systems RFS4000 Cli Reference Manual

User Exec Commands

In this chapter

Logging in to the controller places you within the USER EXEC command mode. Typically, a login
requires a user name and password. You have three login attempts before a connection attempt is
refused. USER EXEC commands (available at the user level) are a subset of the commands
available at the privileged level. In general, USER EXEC commands allow you to connect to remote
devices, perform basic tests and list system information.
To list available USER EXEC commands, use ? at the command prompt. The USER EXEC prompt
consists of the device host name followed by an angle bracket (>). The default host name is
generally "WLAN Module". Use the GLOBAL CONFIG command to change the hostname.
User exec commands
Table 3
TABLE 3
Command
clear
clrscr
cluster-cli
disable
enable
exit
help
logout
no
page
ping
quit
service
show
telnet
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
•
User exec commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 155
summarizes USER EXEC commands:
User Exec Mode Command Summary
Description
Resets the command to the previous configuration
Clears the display screen
Displays the cluster context
Turns off (disables) the privileged mode command set
Turns on (enables) the privileged mode command set
Ends the current mode and moves down to the previous
mode
Describes the interactive help system
Exits the EXEC mode
Negates a command or sets its defaults
Toggles the paging functionality
Sends ICMP echo messages
Exits the current mode and moves to the previous mode
Displays service commands
Shows running system information. Refer to
commands on page 31
Opens a telnet session
Ref.
page 157
page 32
page 159
page 160
page 161
page 33
page 34
page 162
page 35
page 163
page 164
page 165
page 37
Common page 59
page 166
Chapter
3
155