Brocade Communications Systems RFS4000 Cli Reference Manual page 749

Parameters
reader [<index>|
<reader-index-list>]
antenna
[<antenna>|<antenna-list>]
coordinates x
<x-coordinate> y
<y-coordinate> z
<z-coordinate>
reader [<index>|
<reader-index-list>] antenna
[<antenna>|
<antenna-list>] power
<antenna-power>
reader <index> id <ip>
reader <index> coordinates
x
<x-coordinate> y
<y-coordinate>
z <z-coordinate>
reader
[<index>|<reader-index-list
>] description <description>
reader
[<index>|<reader-index-list
>] enable
reader
[<index>|<reader-index-list
>] name <name>
Usage Guidelines
Use
the
reader
Example
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Enter a single RFID reader index or a list (1,3,7) or
range ( 3-7) of RFID reader indices
Configures the RFID readers antenna. Select a antenna using its
index, between <1-8> or range (eg:3-7) of antenna indices or any
RFID reader antenna
•
•
•
•
Configures the RFID reader power.
•
•
Sets the IP address <ip> for the reader with index <index>.
Sets the coordinates for the RFID reader.
•
•
•
•
Sets the description of a RFID reader or a list of readers to
<description> (1-32 characters).
Enables or connects the RFID reader with the index <index> or a
list of RFID readers <reader-index-list>.
Sets a user friendly name to a RFID reader or a group of RFID
readers to <name> (1-20 characters).
[no] reader [<index>|<range>][options]
command
RFController(config-rtls-rfid)#reader 1 antenna 1 coordinates x 400 y 400 z
500
RFController(config-rtls-rfid)#
coordinates - Sets the coordinates for the antenna
x <x-coordinate> – Configures the x coordinate for the
antenna for the RFID reader.
y <y-coordinate> – Configures the y coordinate for the
antenna for the RFID reader.
z <z-coordinate> – Configures the z coordinate for the
antenna for the RFID reader.
power – Sets the power
<antenna-power> – Sets the antenna power to between
<-63 and 63 dBm.
coordinates - Sets the coordinates for the reader
x <x-coordinate> – Configures the x coordinate for the RFID
reader.
y <y-coordinate> – Configures the y coordinate for the RFID
reader.
z <z-coordinate> – Configures the z coordinate for the RFID
reader.
to rollback any configurations performed using
RFID config commands
23
747