Table of Contents
Advertisement
Figure 11 Adjacent channel power measurement with Spectrum Analyzer
Multi adjacent channel power
The Multi-ACP measurement is used to do multi-channel ACP testing. It helps you to
measure ACP in multichannel transmitting base station environment.
Setting measure setup
After configuring spectrum measurement in
page
9, you can set the measure setup to continue your measurement. The measure-
ment settings can be saved and recalled as a file by selecting File Type as Setup and
load the file onto the instrument using the Save/Load icons on the side bar.
To set measure setup
1
Tap the Setup (
2
Tap Main Channel BW to set the main channel bandwidth and input the value
sing the on-screen keyboard.
You can also tap the rectangle with value under the chart screen and input the
value using the on-screen keyboard.
3
Configure the channel settings:
a
b
4
Configure the Frequency settings:
a
b
April 2021
) icon on the sidebar.
Tap Lowest Channel Number and input the value using the on-screen
keyboard.
Tap Highest Channel Number and input the value using the on-screen
keyboard.
Tap Lowest Frequency and input the value using the on-screen keyboard.
You can also tap the rectangle with value under the chard screen and input
the value using the on-screen keyboard.
Tap Highest Frequency and input the value using the on-screen keyboard.
You can also tap the rectangle with value under the chard screen and input
the value using the on-screen keyboard.
SPA06MA-O User's Guide
"Configuring spectrum measurements" on
22145360, R005
Chapter 2 Using Spectrum Analyzer
Conducting RF measurements
Page 29
Advertisement
Table of Contents
