Table of Contents
Advertisement
4
5
1
6
1
7
1
8
1. Not supported on SPA06MA.
Module installation
The following procedure describes how to install the module to the base.
To connect the module to the ONA-800
1
Verify that the power is OFF on your ONA-800 and the power adapter is
unplugged.
2
Remove the back termination cover or CAA/OTDR modules.
3
Remove the screen from the ONA-800 base:
a
April 2021
Trigger In
SMB connector to receive 1PPS clock or 10 ms synchroniza-
tion signals.
Digital CMOS Input DC Coupled
Input signal requirements: Minimum logic high. 2.4V, Maxi-
mum logic high ≥ 3.3V.
GNSS Antenna
SMA connector for GNSS antenna.
SFP+/SFP28
You can use these ports to connect SFP modules to test CPRI
protocols, detect an error or alarm, perform interference analy-
sis, and transmit test pattern over fiber link.
QSFP+/QSFP28
You can use these ports to connect QSFP modules to test
CPRI protocols, detect an error or alarm, perform interference
analysis, and transmit test pattern over fiber link.
Set the unit so you have access to the back. Using the hex key located in the
groove on the back of the ONA-800, loosen the four fasteners, as shown in
Figure
2.
SPA06MA-O User's Guide
22145360, R005
Chapter 1 Overview
Module installation
Page 3
Advertisement
Table of Contents
