Table of Contents
Advertisement
Chapter 5 Using LTE/LTE-A FDD Analyzer
Conducting modulation measurement
To set display
1
Tap Menu > Display.
2
Select the display mode from the choice: PDSCH, PMCH or Both.
To set marker
1
Tap Menu > Marker.
2
Tap the Marker View to On or Off to display or hide the marker on the chart.
3
To select the resource block number, tap the RB Number and enter a value by
using the on-screen keyboard.
4
To select the subframe block number, tap the Subframe No and enter a value by
using the on-screen keyboard.
Figure 52
Figure 52 LTE/LTE-A FDD data allocation map measurement
Carrier aggregation
The Carrier aggregation enables a maximum of five multiple LTE carriers to be used
together in order to provide high data rate required for LTE-Advanced. Component
carriers to be aggregated can be intra-band contiguous, intra-band non-contiguous, or
inter-band.
The SPA06MA-O provides carrier aggregation measurements supporting for all the
different modes with carrier aggregation bands added to the channel standard.
Setting measure setup
After configuring the spectrum measurement in
on page
measurement settings can be saved and recalled as a file by selecting File Type as
Setup and load the file onto the instrument using the Save/Load icons on the side bar.
Page 112
shows an example of LTE/LTE-A FDD data allocation map measurement.
9, you can set the measure setup to continue your measurement. The
SPA06MA-O User's Guide
"Configuring spectrum measurements"
22145360, R005
April 2021
Advertisement
Table of Contents
