Table of Contents
Advertisement
To set measure setup
1
Tap the Setup (
2
Tap the MIMO and select 2x2 or 4x4 to select the number of antenna ports.
3
Tap CA Configuration or tap the Configuration (
General Setting and Carrier Setting table appear.
General setting
1
Tap Trigger to set Internal, External or GPS as required.
–
–
–
Carrier setting
1
Tap Index to select up to 6 numbers of carriers.
2
Select Center Frequency to set the center frequency using the on-screen
keyboard.
3
Select Channel Standard to set the channel standard for the selected index
using the on-screen keyboard.
4
Select Channel Number to set the channel number for the selected index using
the on-screen keyboard.
5
Select Bandwidth from the following options: 1.4 MHz, 3 MHz, 5 MHz, 10 MHz,
15 MHz, or 20 MHz.
6
Tap the External Offset box and input the value using the on-screen keyboard
and tap to switch the external offset to On (green) or Off (gray) as desired.
7
Tap the Attenuation box and input the value using the on-screen keyboard if you
want to set it manually (Manual). Or tap it to set Auto.
8
Tap to switch the Preamp box 1, 2, and Auto to On (green) or Off (gray).
9
Tap the Add button to add Index or Delete button to delete the selected Index.
To set limit
1
Tap Menu > Limit.
2
Tap to switch Limit Line to On or Off.
3
Tap Limit Line and input the value using the on-screen keyboard to enable or
disable Pass/Fail indication.
Figure 54
April 2021
) icon in the side bar.
Internal: when starting a signal processing using the internal reference clock
and creating a trigger
External: when starting a signal processing based on the external input
trigger
GPS: When synchronizing the signal processing via the GPS receiver. If you
want to check the time error correctly, set the trigger to GPS
shows an example of OTA LTE/LTE-A FDD channel scanner measurement.
SPA06MA-O User's Guide
22145360, R005
Chapter 5 Using LTE/LTE-A FDD Analyzer
Conducting OTA measurement
) icon.
Page 115
Advertisement
Table of Contents
