Table of Contents
Advertisement
following is the case of setting trace if you set Axis to Auto and enter into measurement
mode.
1
Tap Menu > Trace in the side bar.
2
Tap Select Trace from 1 to 4.
–
–
–
–
3
Tap to switch Trace View to On or Off.
If you set the Trace from 1 to 4 to off, the trace information in Top Info will indicate
it as F (false).
4
Tap to switch Detectors to RMS or Peak.
a
b
5
Tap Trace Clear All to clear Min/Max/Isotropic EMF/Accumulated Isotropic EMF
traces.
To set limit
1
Tap Menu > Limit in the side bar.
2
Tap Display Line, and then enter a value that you want to set as a reference. The
unit will vary depending on your selection of the unit in the Units setting in Amp/
Scale.
You can also scroll up and down the purple bar on the measurement screen.
3
Tap to switch Display Line Mode to On or Off.
If you set it to On, the display line will appear with the purple bar on the measure-
ment screen and set it to Off, the display line will disappear with the purple bar on
the measurement screen.
4
Tap to switch Standard Line Mode to On to display the standard line on the
screen or Off to hide the standard line on the screen.
5
Tap Standard Limit Line and select from the following options:
April 2021
T1: Maximum trace
T2: Minimum trace
T3: Isotropic EMF trace
T4: Accumulated Isotropic EMF Trace
Tap RMS to display 'The root mean squared average power across the spec-
trum'.
Tap Peak to display 'The highest value in each data point'.
NOTE
Trace Clear All resets traces you have set and it also affects overall measure-
ment (Max, Min, etc...) and measurement result. Therefore, you need to be
cautious when using this function.
SPA06MA-O User's Guide
22145360, R005
Chapter 11 Using EMF Analyzer
Conducting spectrum measurement
Page 381
Advertisement
Table of Contents
