Table of Contents
Advertisement
Chapter 7 Using 5G NR Signal Analyzer
Conducting RF measurements
8
Tap SSB Auto Search Mode and do the following steps:
a
b
9
Tap SSB Periodicity and select the options from 5 ms, 10 ms, 20 ms, 40 ms, 80
ms, 160 ms. The SS burst period (SSB periodicity) is defined by each base
station and network configurable. 20 ms is the default for the initial cell selection.
10 Tap to switch PCI (Physical Cell ID) to Manual or Auto.
11 Tap PCI and input a value from 0 to 1007 using the on-screen keyboard. The PCI
switches to Manual.
12 Tap EIRP Settings.
a
b
c
d
e
f
Page 194
Tap Auto Preamp/Atten and switch SSB Auto Search to Start to set
preamp and attenuation automatically.
Tap Manual and switch SSB Auto Search to Start for manually setting
based on your need.
NOTE
If you tap SSB Auto Search to Start, the searching progress screen appears to
let you know the status of searching.
You can tap SSB Auto Search to Stop to stop searching.
Select Set Max to EIRP1 to save the currently measured maximum value to
EIRP1.
Select Set Max to EIRP2 to save the currently measured maximum value to
EIRP2.
Select Clear Max to clear the currently measured maximum value.
Select Clear All to reset EIRP1, EIRP2, and maximum value.
Tap Distance and input the value using the on-screen keyboard.
Tap Antenna Gain and input the value using the on-screen keyboard.
SPA06MA-O User's Guide
22145360, R005
April 2021
Advertisement
Table of Contents
