Selecting Mode And Measure; Conducting Spectrum Measurements; Trigger Spectrum - Viavi SPA06MA-O R005 User Manual

Selecting mode and measure

The following procedure describes how to start measurement.
To select mode and measure
1 Tap
2 Tap any measurement mode from the following choices:
–
–
–
–
–
–

Conducting spectrum measurements

The following sections describe how to conduct spectrum measurements.

Trigger spectrum

Setting measure setup
After configuring the spectrum measurement can configure the measurements just as
in Spectrum mode. For more information, see
on page
Setup and load the file onto the instrument using the Save/Load icons on the side bar.
To set measure setup
1 Tap the Setup (
2 Tap Bandwidth/SSB SCS and select the Setting in the pop-up window based on
your need. SSB is abbreviation for Synchronization Signal Block or SS Block and
it refers to Synchronization PBCH block since the synchronization signal and
PBCH channel are packed as a single block that always moves together. SSB
should be detected first in 5G NR frame. See
criteria based on the operating frequency.
April 2021
5G NR Signal Analyzer on the MODE panel
Spectrum Analysis > Trigger Spectrum
RF Analysis > Channel Power, Occupied Bandwidth, Spectrum Emis-
sion Mask, ACLR, Multi-ACLR, or Spurious Emissions
OTA Analysis > Beam Analyzer, Carrier Scanner, Route Map, Beam
Availability Index, Freq/Time Error Variation, or Multipath Profile
Modulation Analysis > Constellation
Power vs Time > Power vs Time (Slot), Power vs Time (Frame)
PDSCH Analysis > PDSCH Constellation, EVM vs Subcarrier, or Alloca-
tion Mapper
9.The measurement settings can be saved and recalled as a File Type as
) icon in the side bar.
SPA06MA-O User's Guide
.
"Configuring spectrum measurements"
Table 24
22145360, R005
Chapter 7 Using 5G NR Signal Analyzer
Selecting mode and measure
below for the setting
Page 189