Table of Contents
Advertisement
To load a map
1
Plug in your USB flash drive that has a map file in .mcf file type created in JDMap-
Creator.
2
Tap the Load icon on the side bar.
3
Navigate to the map you want to open. The File Information pane displays the
file properties, including name, size, type, and date modified.
4
Tap the Load button on the screen.
Once you have loaded the map, you can also control the map using the following icons
on the map.
Table 14 Map control icons
Icon
Initializing AntennaAdvisor
Once you have connected the AntennaAdvisor Handle to your instrument, antenna
initialization is required to get the right azimuth data. You need to initialize the antenna
handle to calibrate the built-in compass by completing the following steps. Note that you
can adjust Bandwidth based on the center frequency of the interfering signal that you
have identified in the Spectrum view by tapping Measure Setup > Bandwidth. A
message appears at the bottom of the screen to alert you if you have not performed
initialization of your connected the antenna handle set.
April 2021
Description
Tap to go to your current location on the map. Once tapped, the purple icon
appears on the map, indicating your current location.
Tap to switch to the full screen map view.
Tap to zoom in the map.
Tap to zoom out the map.
Tap and select the area where you want to expand.
SPA06MA-O User's Guide
22145360, R005
Chapter 3 Using Interference Analyzer
Conducting interference measurements
Page 47
Advertisement
Table of Contents
