Selecting Mode And Measure; Conducting Spectrum Measurement; Spectrum - Viavi SPA06MA-O R005 User Manual

Selecting mode and measure

The following procedure describes how to start measurement.
To start measurement
1 Tap LTE/LTE-A TDD Analyzer on the MODE panel.
2 Tap any measurement mode from the following choices:
–
–
–
–
–
–

Conducting spectrum measurement

The following sections describe how to conduct spectrum analysis.

Spectrum

After setting test parameters as described in
page 9, your measurement is displayed on the screen as like the following example.
You can simply change Center Frequency by tapping the icons right below the result
chart screen.
To set measure setup
1 Tap the Setup (
2 Tap Bandwidth and select the value from the following choices: 1.4 MHz, 3 MHz,
5 MHz, 10 MHz, 15 MHz or 20 MHz.
3 Tap the Center Frequency (
screen to set the center frequency using the on-screen keyboard.
4 Tap Subframe Number and input the value from 0 to 9 using the on-screen
keyboard.
April 2021
Spectrum Analysis > Spectrum
RF Analysis > Channel Power, Occupied Bandwidth, Spectrum Emis-
sion Mask, ACLR, Multi-ACLR, or Spurious Emissions
Power vs Time > Power vs Time (Frame) or Power vs Time (Slot)
Modulation Analysis > Constellation, Data Channel, Control Channel,
Subframe, Time Alignment Error, Data Allocation Map, or Carrier Aggre-
gation
OTA Analysis > OTA Channel Scanner, OTA ID Scanner, OTA Multipath
Profile, OTA Control Channel, OTA Datagram, OTA Route Map, or Freq/
Time/Power Variation
Miscellaneous > Power Statistics CCDF
) icon in the side bar.
SPA06MA-O User's Guide
"Configuring spectrum measurements" on
22145360, R005
Chapter 6 Using LTE/LTE-A TDD Analyzer
Selecting mode and measure
)icon under the chart
Page 135