Table of Contents
Advertisement
Setting trace
You can display up to six traces on the measurement chart simultaneously.
To set trace
1
Tap Menu > Trace.
2
Tap Select Trace and select the trace number: Trace 1, Trace 2, Trace 3, Trace
4, Trace 5, or Trace 6.
3
Complete one of the following by tapping Trace Type:
–
–
–
–
–
–
–
4
To remove all the traces and initialize the trace settings, tap Trace Clear All.
5
Tap Detectors and select the detection option:
–
–
–
–
–
6
Optional: Select Trace Info, and then select the trace number to view the trace's
parameter setting information stored at the time of measurement, or None to hide
the information display.
April 2021
Clear Write: Clear current data and display with new measurements
Max: Display the input signal's maximum response only (unlimited or for a
certain amount of time)
Min: Display the input signal's minimum response only (unlimited or for a
certain amount of time)
Capture: Capture the selected trace and compare traces
Load: Load a saved trace
Trace View to Off: Hide the displayed trace
Trace Set Max/Min: To set Trace 1, Trace 2, and Trace 3 to Clear Write, Max,
and Min (only available in spectrum mode)
NOTE
For the Max and Min, your instrument compares newly acquired data with the
active trace and displays larger maximum values or smaller minimum values
on the screen.
Normal: Displays "Random noise better than the peak without missing
signals"
Peak: Displays "The highest value in each data point."
RMS: Displays "The root mean squared average power across the spec-
trum."
Negative Peak: Displays "The lowest value in each data point."
Sample: Displays "The center value in each data point."
NOTE
To be able to load a trace, the trace to be overlaid must be saved in the same
measurement mode and frequency setting as the current measurement.
SPA06MA-O User's Guide
22145360, R005
Chapter 10 Using RFoCPRI Analyzer
Configuring test parameters
Page 361
Advertisement
Table of Contents
