Table of Contents
Advertisement
6
Tap Channel Number and input a value using the on-screen keyboard.
7
Tap the Continue button on the right edge to continue.
8
Set the parameters that appear in the table below the chart screen as needed.
Figure 28
Figure 28 PIM detection — single carrier
To make a multi carrier measurement
1
Connect the cables as instructed on the screen.
2
Optional: Check for PIM existence in red by calculation.
a
b
c
d
e
f
3
Tap Uplink Center Frequency and input a value using the on-screen keyboard.
4
Tap Uplink Span and input a value using the on-screen keyboard.
April 2021
shows an example of a single carrier PIM Detection measurement.
Tap Calculated PIM.
Check the Radio 2 Band and its information in the table.
Tap to switch Mode to Band or Frequency.
If Band is selected:
-
Tap Radio 1 Band and select the technology and band from the channel
list.
-
Tap Radio 2 Band and select the technology and band from the channel
list.
If Frequency is selected:
-
Tap Frequency 1 Band and select the technology and band from the
channel list.
-
Tap Frequency 2 Band and select the technology and band from the
channel list.
Tap the X button to return to the previous screen.
SPA06MA-O User's Guide
22145360, R005
Chapter 3 Using Interference Analyzer
Utility
Page 57
Advertisement
Table of Contents
