Table of Contents
Advertisement
Chapter 6 Using LTE/LTE-A TDD Analyzer
Conducting RF measurement
7
Tap Channel Standard and select and apply the channel standard in the Band
Global list.
To set limit
1
Tap Menu > Limit.
2
Tap to switch the Test Limits to On or Off to enable or disable Pass/Fail indica-
tion.
The result table color for Pass is green, and the result table color for Fail is red.
3
Optional: Tap the Save hot key on the side bar and select the save option from the
choices available for your measurement mode.
Figure 73
Figure 73 LTE/LTE-A TDD Multi-ACLR measurement
Spurious emissions
The Spurious Emissions measurement is to identify or determine the power level of in-
band or out-of-band spurious emissions within the necessary channel bandwidth and
modulated signal. The SPA06MA-O indicates either Pass or Fail based on the
specified limit of the signal.
Setting measure setup
After configuring the spectrum measurement in
on page
measurement settings can be saved and recalled as a file by selecting File Type as
Page 144
shows an example of LTE/LTE-A TDD Multi-ACLR measurement.
NOTE
You can set the Lowest Ref. Frequency and Highest Ref. Frequency by
tapping the rectangle with value using the on-screen keyboard.
9, you can set the measure setup to continue your measurement. The
SPA06MA-O User's Guide
"Configuring spectrum measurements"
22145360, R005
April 2021
Advertisement
Table of Contents
