Table of Contents
Advertisement
Figure 72 LTE/LTE-A TDD ACLR measurement
Multi-ACLR
The Multi-ACLR measurement is used to perform multi-channel ACLR measurements
with as many channels as possible. It helps you to measure ACLR in multi-channel
transmitting Base Station environment.
Setting measure setup
After configuring the spectrum measurement in
on page
measurement settings can be saved and recalled as a file by selecting File Type as
Setup and load the file onto the instrument using the Save/Load icons on the side bar.
To set measure setup
1
Tap the Setup (
2
Tap Bandwidth and select the value from the following choices: 1.4 MHz, 3 MHz,
5 MHz, 10 MHz, 15 MHz or 20 MHz.
You can also tap the rectangle with value,(
the chart screen and input the value using the on-screen keyboard.
3
Tap Lowest Frequency to set the starting center frequency and enter the value
using the on-screen keyboard.
4
Tap Highest Frequency to set the stopping center frequency and enter the value
using the on-screen keyboard.
5
Tap Lowest Channel Number to set the starting channel and enter the value
using the on-screen keyboard.
6
Tap Highest Channel Number to set the stopping Channel and enter the value
using the on-screen keyboard.
April 2021
9, you can set the measure setup to continue your measurement. The
) icon in the side bar.
SPA06MA-O User's Guide
"Configuring spectrum measurements"
22145360, R005
Chapter 6 Using LTE/LTE-A TDD Analyzer
Conducting RF measurement
) under
Page 143
Advertisement
Table of Contents
