Table of Contents
Advertisement
2
Tap to switch Carrier Auto Search to Start to start searching the SSB frequency
and apply it or to Stop to stop searching.
3
Tap to switch Radio Config and set Duplex Type (FDD/TDD), DSS Type (Co-
channel) and Technology (LTE/NR) and other related parameters as below:
You can select Co-channel to find NR frequency based on the LTE operating
frequency in co-channel and select Adjacent channel to search both LTE and NR
frequency. Note that Adjacent channel will be available in the next release.
•
When LTE is selected as Technology, do the following steps:
–
–
–
–
•
When NR is selected as Technology, do the following steps:
–
4
Tap Subframe Number from 0 to 9.
5
Tap Antenna Port to assign an antenna port number automatically or manually,
and select from Auto, Antenna 0, or Antenna1.
If the MIMO is set to 2x2, the antenna ports 2 and 3 are disabled.
6
Tap to switch CFI to Manual or Auto.
–
–
April 2021
NOTE
If searching is unavailable, the instrument displays a pop-up message saying
that it fails to detect NR (SSB)
frequency.
Select Bandwidth (MHz) from the following choices: 20, 15, 10, or 5.
Select MIMO between 2x2 and 4x4 to set the number of antenna ports. If the
MIMO is set to 2x2, the antenna ports 2 and 3 are disabled.
Select Cyclic Prefix between Normal and Extended. Cyclic prefix works as
a buffer region or guard interval to protect the OFDM signals from inter
symbol interference.
-
Normal: Intended to be sufficient for the majority of scenarios
-
Extended: Intended for scenarios with particularly high delay spread
Select PHICH Ng between Normal and Extended and then to set the
number of PHICH groups (Ng): 1/6, 1/2, 1, or 2. The PHICH group value/Ng
is decided based on the number of PHICH groups per subframe. PHICH
duration is a higher layer parameter configured either as Normal or Extended
that says the demodulator how many symbols per subframe are used by
PHICH.
Normal: There are 8 PHICH sequences in one PHICH group (4
-
symbols).
-
Extended: There are 4 PHICH sequences in one PHICH group (2
symbols)
Select Sub-Carrier Spacing as 15 kHz (Case A). The standard for NR SCS is
15 kHz. The instrument supports 15 kHz of sub-carrier spacing.
Auto lets the instrument set the number of OFDM symbols used for transmit-
ting PDCCHs in a subframe.
Manual sets the number of OFDM symbols manually. The set of OFDM
symbols that can be used for PDCCH in a subframe is given by 0, 2, 3 or 4 in
1.4 MHz bandwidth and 1, 2 or 3 in other bandwidths.
SPA06MA-O User's Guide
22145360, R005
Chapter 9 Using 5G DSS Signal Analyzer
Conducting modulation measurements
Page 311
Advertisement
Table of Contents
