Table of Contents
Advertisement
Figure 31 Persistent spectrogram measurement
To set measure setup
After configuring spectrum measurement as described in
measurements" on page
ment.
1
Tap the Setup (
2
Tap Time Interval to set the amount of time between each trace measurement
using the on-screen keyboard.
3
Tap Time Cursor to On to set the time cursor on a specific trace position.
The Position menu becomes activated to be set. You can also move the time
cursor up and down using the move bar on the left edge.
4
Tap Position to move the time cursor by inputting a value using the on-screen
keyboard.
5
Tap Type to switch the chart view type to 3d Display or Normal.
You can also change the cart view type using the icon on the chart screen.
6
Tap POI. You can also access this menu via Quick Access and Display Tab on
top.
a
April 2021
60, you can set the measure setup to continue your measure-
) icon on the side bar.
Tap to switch the Mode between High and Normal.The following table shows
RBW and Span setup range per Normal and High Mode
SPA06MA-O User's Guide
Chapter 4 Using Real-Time Spectrum Analyzer
22145360, R005
Conducting spectrum measurements
"Conducting spectrum
Page 65
Advertisement
Table of Contents
