Chapter 4 Using Real-Time Spectrum Analyzer
Conducting spectrum measurements
To set measure setup for Interference ID
The Interface ID automatically classifies interfering signals over a designated spectrum
and displays the list of possible signal types corresponding to the selected signal.
1
Tap the Setup (
2
Tap Interference ID.
a
b
To set measure setup for POI
The interference ID automatically classifies interfering signals over a designated spec-
trum and displays the list of possible signal types corresponding to the selected signal.
1
Tap the Setup (
Page 62
) icon on the side bar.
Tap to switch the Interference ID between On and Off to turn the Interference
ID on and off.
Tap Threshold and input a value using the on-screen keyboard.
) icon on the side bar.
SPA06MA-O User's Guide
22145360, R005
April 2021