Table of Contents
Advertisement
To set measure setup
1
Tap the Setup (
2
Tap Bandwidth and select the value from the following choices: 1.4 MHz, 3 MHz,
5 MHz, 10 MHz, 15 MHz or 20 MHz.
3
Optional. Tap Physical Cell ID and select the type Manual or Auto.
–
–
4
Tap to switch PCI (Physical Cell ID) to Manual or Auto.
5
Optional. Tap CFI and select the type Manual or Auto.
–
–
6
Optional. Tap PHICH Ng to set the number of PHICH groups (Ng): 1/6, 1/2, 1, 2,
E-1/6, E-1/2, E-1, or E-2.
7
Tap EVM Detection Mode and select Single or Combine.
–
–
April 2021
) icon in the side bar.
Auto lets the instrument detect the Physical Cell ID for the LTE signal auto-
matically.
Manual sets the specific Physical Cell ID for the LTE signal manually in order
to speed up the synchronization with a BTS.
Auto lets the instrument set the number of OFDM symbols used for transmit-
ting PDCCHs in a subframe.
Manual sets the number of OFDM symbols manually. The set of OFDM
symbols that can be used for PDCCH in a subframe is given by 0, 2, 3 or 4 in
1.4 MHz bandwidth and 1, 2 or 3 in other bandwidths.
Single: Testing on one single antenna connected to your instrument with a
cable
Combine: Testing on multiple antennas connected to your instrument with a
2x1 or 4x1 combiner or an antenna
SPA06MA-O User's Guide
22145360, R005
Chapter 5 Using LTE/LTE-A FDD Analyzer
Conducting OTA measurement
Page 129
Advertisement
Table of Contents
