Table of Contents
Advertisement
Chapter 4 Using Real-Time Spectrum Analyzer
Conducting interference analysis
Once you have loaded the map, you can also control the map using the following icons
on the map.
Table 20 Map control icons
Icon
Initializing AntennaAdvisor
Once you have connected the AntennaAdvisor Handle to your instrument, antenna
initialization is required to get the right azimuth data. You need to initialize the antenna
handle to calibrate the built-in compass by completing the following steps. Note that you
can adjust Bandwidth based on the center frequency of the interfering signal that you
have identified in the Spectrum view by tapping the Setup > Bandwidth. A message
appears at the bottom of the screen to alert you if you have not performed initialization
of your connected the antenna handle set.
To initialize AntennaAdvisor
1
Hold your antenna handle horizontally in its upright position.
To avoid unnecessary impact of external magnetic field, position yourself at the
location where the value of magnetic field strength displayed on the instrument is
green.
2
Point the antenna to the north and tap Measure Setup > Initialize AntennaAd-
visor.
Page 76
Description
Tap to go to your current location on the map. Once tapped, the purple icon
appears on the map, indicating your current location.
Tap to switch to the full screen map view.
Tap to zoom in the map.
Tap to zoom out the map.
Tap and select the area where you want to expand.
SPA06MA-O User's Guide
22145360, R005
April 2021
Advertisement
Table of Contents
