Table of Contents
Advertisement
Chapter 6 Using LTE/LTE-A TDD Analyzer
Conducting modulation measurement
Figure 82 LTE/LTE-A TDD data allocation map measurement
Carrier aggregation
The Carrier aggregation enables a maximum of five multiple LTE carriers to be used
together in order to provide high data rate required for LTE-Advanced. Component
carriers to be aggregated can be intra-band contiguous, intra-band non-contiguous, or
inter-band.
The SPA06MA-O provides carrier aggregation measurements supporting for all the
different modes with carrier aggregation bands added to the channel standard.
Setting measure setup
After configuring the spectrum measurement in
on page
measurement settings can be saved and recalled as a file by selecting File Type as
Setup and load the file onto the instrument using the Save/Load icons on the side bar.
To set measure setup
1
Tap the Setup (
2
Tap CA Configuration or tap the Configuration (
carrier configuration window appears.
3
Select the number of the component carrier to be set between one and five by
tapping the number in Range box.
4
Set the Range On to set parameters and view the results for the selected compo-
nent carrier on the screen or Off to turn it off.
5
Tap LAA (License Assisted Access) and select one among the three options: 2.4
GHz, 5 GHz, or Off.
6
Set the following parameters as needed: Center Frequency, Channel No, Band-
width, Physical Cell ID, MBMS, MBSFN, MIMO, Antenna Port, CFI, PHICH Ng,
Cyclic Prefix, and PDSCH Modulation Type.
Page 166
9, you can set the measure setup to continue your measurement. The
) icon in the side bar.
SPA06MA-O User's Guide
"Configuring spectrum measurements"
22145360, R005
) icon then the component
April 2021
Advertisement
Table of Contents
