Conducting Spectrum Measurements; Spectrum - Viavi SPA06MA-O R005 User Manual

2 Tap any measurement mode from the following choices:
–
–
–

Conducting spectrum measurements

The following sections describe how to conduct spectrum measurements.

Spectrum

Most spectrum measurements of the interference analyzer are also available in Spec-
trum mode. Using these measurements allows you to located interferences in the
frequency spectrum. You can configure the measurements just as in Spectrum mode.
For more information, see
The spectrum measurement with an audible indicator is especially useful for locating
interferer sources with a directional antenna.
To set measure setup for sound indicator
1 Tap the Setup (
2 Tap Sound Indicator.
a
b
c
d
e
April 2021
Spectrum Analysis > Spectrum or Spectrogram
Interference Analysis > RSSI, Interference Finder or Radar Chart
Utility > Spectrum Replayer > PIM Detection Single Carrier or PIM Detec-
tion Multi Carrier
NOTE
You can choose RF Source On or Off in setup menu after tapping CAA RF
Power On if you have RF Source option in your CAA (Cable and Antenna
Analyzer.)
"Configuring spectrum measurements" on page
) icon on the side bar.
Tap to switch the Sound between On and Off to enable and disable the
alarm sound.
Tap to switch the Alarm Reference to Marker to set the active marker posi-
tion as the alarm reference.
Tap to switch the Alarm Reference to Line to set the limit as the alarm refer-
ence.
Select Reference Line to specify a threshold for the reference line using the
on-screen keyboard.
Optional: To adjust the volume for alarm sound, tap Volume and input a value
from 1 to 10 using the on-screen keyboard.
SPA06MA-O User's Guide
22145360, R005
Chapter 3 Using Interference Analyzer
Conducting spectrum measurements
9.
Page 41