Table of Contents
Advertisement
3
Tap to switch the Plot Point to GPS, Position, or Time.
a
–
–
b
c
4
Tap Bandwidth and select the value from the following choices: 1.4 MHz, 3 MHz,
5 MHz, 10 MHz, 15 MHz or 20 MHz.
5
Tap to switch Physical Cell ID to Manual or Auto.
–
–
6
If you set the Physical Cell ID to Manual, tap Physical Cell ID and input the value
using the on-screen keyboard.
7
Optional: Tap the Save icon on the side bar and select the save option from the
choices available for your measurement mode.
To set limit
You can set the thresholds for the two different color indicators, red and blue. The
maximum value is the Limit for Excellent, and the minimum value is the Limit for Poor.
See below to check the plot point color based on the Legend Color Table.
1
Tap the rectangle with value before color legend bar on the right panel.
2
Set a value for Poor (minimum value) using the on-screen keyboard.
3
Tap the rectangle with value after color legend bar on the right panel.
4
Set a value for Excellent (maximum value) using the on-screen keyboard.
Figure 92
April 2021
To collect data/plot points automatically as you move around in a vehicle or
outside, select GPS, then tap to switch the Screen Mode between Map and
Full.
With the Map setting, you can view only the collected points that can be seen
within the boundary of the loaded map.
With the Full setting, you can view all the collected points of the route without
the loaded map.
To collect data/plot points manually in an indoor layout without a GNSS
antenna, select Position.
To collect data/plot points based on time, select Time.
Auto lets the instrument detect the Physical Cell ID for the LTE signal auto-
matically
Manual sets a specific Physical Cell ID for the LTE signal manually in order to
speed up the synchronization with a BTS.
NOTE
The instrument does not automatically save the collected data. It is recom-
mended that you save the result. If not, you will lose all the collected data.
shows a legend color table.
SPA06MA-O User's Guide
22145360, R005
Chapter 6 Using LTE/LTE-A TDD Analyzer
Conducting OTA measurement
Page 179
Advertisement
Table of Contents
