Table of Contents
Advertisement
Selecting mode and measure
The following procedure describes how to start measurement.
To start measurement
1
Tap LTE/LTE-A FDD Analyzer on the MODE panel.
2
Tap any measurement mode from the following choices:
–
–
–
–
–
–
Conducting spectrum measurement
The following sections describe how to conduct spectrum analysis.
Spectrum
After setting test parameters as described in
page
9, your measurement is displayed on the screen as like the following example.
You can simply change Center Frequency by tapping the icons right below the result
chart screen.
To set measure setup
1
Tap the Setup (
2
Tap Bandwidth and select the value from the following choices: 1.4 MHz, 3 MHz,
5 MHz, 10 MHz, 15 MHz or 20 MHz.
3
Tap the Center Frequency (
screen to set the center frequency using the on-screen keyboard.
To set trigger
1
Tap the Menu > Trigger.
2
Tap Trigger and select the options from Internal, External, or GPS.
April 2021
Spectrum Analysis > Spectrum
RF Analysis > Channel Power, Occupied Bandwidth, Spectrum Emis-
sion Mask, ACLR, Multi-ACLR, or Spurious Emissions
Power vs Time > Power vs Time (Frame)
Modulation Analysis > Constellation, Data Channel, Control Channel,
Subframe, Frame, Time Alignment Error, Data Allocation Map, or Carrier
Aggregation
OTA Analysis > OTA Channel Scanner, OTA ID Scanner, OTA Multipath
Profile, OTA Control Channel, OTA Route Map, or Freq/Time/Power Vari-
ation
Miscellaneous > Power Statistics CCDF
) icon in the side bar.
SPA06MA-O User's Guide
"Configuring spectrum measurements" on
22145360, R005
Chapter 5 Using LTE/LTE-A FDD Analyzer
Selecting mode and measure
)icon under the chart
Page 85
Advertisement
Table of Contents
