Table of Contents
Advertisement
Figure 115 5G NR beam availability index
Freq/Time/Power variation
The frequency, time, and power variation shows the frequency, time, and power error
trend based on the time elapsed.
After configuring the spectrum measurement in
on page
measurement settings can be saved and recalled as a file by selecting File Type as
Setup and load the file onto the instrument using the Save/Load icons on the side bar.
Setting measure setup
To set measure setup
1
Tap the Setup (
2
Tap Bandwidth/SSB SCS and select the Setting in the pop-up window based on
your need. SSB is abbreviation for Synchronization Signal Block or SS Block and
it refers to Synchronization PBCH block since the synchronization signal and
PBCH channel are packed as a single block that always moves together. SSB
should be detected first in 5G NR frame. See
criteria based on the operating frequency.
3
Tap Sync Raster Offset to set the sync raster resolution to 180 kHz (FR1) or to
720 kHz (FR2) for carrier frequency center using the on-screen keyboard. See
Table 51
resolution.
April 2021
NOTE
You can adjust SSB frequency using the purple scroll bar on the chart. You can
see the constellation information by selecting either PBCH or PBCH DM-RS.
9, you can set the measure setup to continue your measurement. The
) icon in the side bar.
below for the sync raster offset range per SSB SCS and sync raster
SPA06MA-O User's Guide
"Configuring spectrum measurements"
Table 50
22145360, R005
Chapter 7 Using 5G NR Signal Analyzer
Conducting OTA measurement
below for the setting
Page 231
Advertisement
Table of Contents
