Table of Contents
Advertisement
•
S-SS RSRP (Secondary Synchronized Signal – Reference Signal Received
Power) — linear average over the power contributions (in Watts) of the resource
elements which carry secondary synchronization signals
•
P-SS SNR (Primary Synchronization Signal – Signal to Noise Ratio) — ratio
of signal power to the noise power through the primary sync signals
•
Channel Power — integrated power of the entire channel bandwidth (100 MHz)
during an entire transmission frame (10ms)
To set measure setup
After configuring the spectrum measurement in
on page
menus for NSA analyzer are available in the screen with two categories: general
setting and carrier setting. You can setup up to 8 carriers for each NR and LTE
simultaneously.
General setting
1
Tap the Setup (
2
Tap General Setting on the screen.
3
To set the reference level, tap the number under NR or LTE and input the refer-
ence level using the on-screen keyboard.
4
Tap to switch the Sweep Speed between Fast and Normal.
–
–
5
Tap Trigger to set Internal, External or GPS as required.
–
–
–
6
Tap to switch Sorting Type to PCI or RSRP as required.
April 2021
9, you can set the measure setup to continue your measurement. The setup
) icon > Configuration in the side bar.
Fast: measuring PCI, RSRP, RSRQ, P-SS SNR, S-SS SINR, S-SS RSSI, P-
SS Power, S-SS Power for one signal with the strongest RSRP for LTE
carrier/ measuring PCI, SSB Index, S-SS RSRP, P-SS RSRP, P-SS SNR, S-
SS SINR, S-SS RSRQ for one signal with the strongest S-SS RSRP for NR
carrier
Normal: measuring PCI, RSRP, RSRQ, P-SS SNR, S-SS SINR, S-SS RSSI,
P-SS Power, S-SS Power for six signal with top-down order based on the
strongest RSRP signal for LTE carrier/ measuring PCI, SSB Index, S-SS
RSRP, P-SS RSRP, P-SS SNR, S-SS SINR, S-SS RSRQ for eight signals
with top-down order based on the strongest S-SS RSRP signal for NR carrier
Internal: when starting a signal processing using the internal reference clock
and creating a trigger
External: when starting a signal processing based on the external input
trigger
GPS: When synchronizing the signal processing via the GPS receiver. If you
want to check the time error correctly, set the trigger to GPS
SPA06MA-O User's Guide
"Configuring spectrum measurements"
22145360, R005
Chapter 8 Using NSA Signal Analyzer
Conducting OTA measurements
Page 275
Advertisement
Table of Contents
