Conducting Spectrum Measurements; Conducting Rf Measurements - Viavi SPA06MA-O R005 User Manual

Chapter 2 Using Spectrum Analyzer

Conducting spectrum measurements

2 Tap Select Trace, and select the trace from Trace 1 to Trace 6.
3 Tap Trace View and select On.
The selected marker moves to the selected trace.
Conducting spectrum measurements
If you have configured test patterns as described in
ments" on page
on page
the result chart screen.
Figure 6

Conducting RF measurements

The following sections describe how to conduct RF measurements.
Page 22
NOTE
If the marker is beyond the frequency range, the purple horizontal move bar
appears on the left and right edge of the chart screen. You can move the
marker by moving the bar right and left.
9, your measurement is displayed on the screen, as shown in
22. You can change Center Frequency and Span by tapping the icons below
Sweep tuned spectrum measurement with spectrum analyzer.
NOTE
If the sweep mode is set to Normal and RBW is 300 Hz or below, the Sweep
Type changes to FFT. If the Sweep Mode is set to Fast and RBW is 30 kHz or
below, the Sweep Type changes to FFT.
SPA06MA-O User's Guide
22145360, R005
"Configuring spectrum measure-
Figure 6
April 2021