Table of Contents
Advertisement
You can also tap the rectangle with value,(
the chart screen and input the value using the on-screen keyboard.
3
Tap Subframe Number and input the value from 0 to 9 using the on-screen
keyboard.
4
Optional. Tap to switch Physical Cell ID to Manual or Auto.
–
–
5
To select the number of antenna ports, tap the MIMO and select 2x2 or 4x4.
6
To assign an antenna port number automatically or manually, tap the Antenna
Port under Antenna menu and select the option: Auto, Antenna 0, Antenna 1,
Antenna 2, or Antenna 3.
If the MIMO is set to 2x2, the antenna ports 2 and 3 are disabled.
7
Tap Cyclic Prefix and select Normal or Extended.
8
Tap Delay and enter a value using the on-screen keyboard to set the amount of
delay in μs.
9
Tap Special Subframe and enter a value using the on-screen keyboard.
To set limit
1
Tap Menu > Limit.
2
Tap the test items and set the limits depending on your selected measurement
mode:
To set the limit for
Subframe Power
Frame Avg Power
Time Offset
IQ Origin Offset
3
Optional: Tap the Save hot key on the side bar and select the save option from the
choices available for your measurement.
Figure 75
April 2021
Auto lets the instrument detect the Physical Cell ID for the LTE signal auto-
matically
Manual sets a specific Physical Cell ID for the LTE signal manually in order to
speed up the synchronization with a BTS.
Select and set
Test limits On/Off, High/Low Limit
Test limits On/Off, High/Low Limit
Test limits On/Off, High/Low Limit
Test limits On/Off, High Limit
shows an example of LTE/LTE-A TDD power vs time (Frame) measurement.
SPA06MA-O User's Guide
22145360, R005
Chapter 6 Using LTE/LTE-A TDD Analyzer
Power vs Time
) under
Page 147
Advertisement
Table of Contents
