Table of Contents
Advertisement
PBCH channel are packed as a single block that always moves together. SSB
should be detected first in 5G NR frame. See
criteria based on the operating frequency.
3
Tap Sync Raster Offset to set the sync raster resolution to 180 kHz (FR1) or to
720 kHz (FR2) for carrier frequency center using the on-screen keyboard. See
Table 34
resolution.
4
Tap Sync SCS Offset to fine-tune the offset using the SCS. See
for the sync raster offset range per SSB SCS and sync raster resolution.
5
Tap SSB Center Frequency and input the value using the on-screen keyboard.
6
Tap GSCN and input the value using the on-screen keyboard.
Based on GSCN input frequency, the SSB frequency changes automatically.
7
Tap L to set the maximum number of SS-PBCH blocks within a single SS burst
set (A set of SS being transmitted in 5 ms window of SS transmission) among 4, 8
and 64. Refer to the selection criteria based on the table in Step 2.
8
Tap SSB Auto Search Mode and do the following steps:
a
b
9
Tap SSB Periodicity and select the options from 5 ms, 10 ms, 20 ms, 40 ms, 80
ms, 160 ms. The SS burst period (SSB periodicity) is defined by each base
station and network configurable. 20 ms is the default for the initial cell selection.
10 Tap to switch PCI (Physical Cell ID) to Manual or Auto.
11 Tap PCI and input a value from 0 to 1007 using the on-screen keyboard. The PCI
switches to Manual.
12 Tap SEM Config to configure the following items:
a
b
April 2021
below for the sync raster offset range per SSB SCS and sync raster
Tap Auto Preamp/Atten and switch SSB Auto Search to Start to set
preamp and attenuation automatically.
Tap Manual and switch SSB Auto Search to Start for manually setting
based on your need.
NOTE
If you tap SSB Auto Search to Start, the searching progress screen appears to
let you know the status of searching.
You can tap SSB Auto Search to Stop to stop searching.
Tap BS Type and select the option from 1-C/1-H, 1-O, or 2-O.
Set 1-C (Conducted)/1-H (Hybrid) for multi-band operation with mapping of
transceivers to one or more antenna connectors (1-C) or TAB (transceiver
array boundary) connectors for 1-H. Set 1-O when BS operates at FR1 and
2-0 when BS operates at FR2.
Tap Category and select the option from Wide Area BS A, Wide Area BS B,
Medium Range BS, or Local Area BS.
SPA06MA-O User's Guide
Table 33
22145360, R005
Chapter 7 Using 5G NR Signal Analyzer
Conducting RF measurements
below for the setting
Table 35
below
Page 201
Advertisement
Table of Contents
