Table of Contents
Advertisement
Chapter 3 Using Interference Analyzer
Conducting interference measurements
To initialize AntennaAdvisor
1
Hold your antenna handle horizontally in its upright position.
To avoid the unnecessary impact of an external magnetic field, position yourself at
the location where the value of the magnetic field strength displayed on the instru-
ment screen is green.
2
Point the antenna to the north and tap Measure Setup > Initialize AntennaAd-
visor.
The message disappears and the red line for the current antenna direction moves
to the 0° line and overlaps to let you know that the initialization has completed
successfully.
Setting geographic location
A point is a particular location that contains information about that location. This infor-
mation includes, for example, GNSS coordinates, the time of the measurement or level
that has been measured. You can evaluate the Point information directly on-site or save
the information for later evaluation.
With this functionality, you can mark locations where you have performed a measure-
ment. Thus, you can analyze the geographical distribution of the received signal
strength. This allows you to analyze, for example, the coverage conditions around a
base station's coverage area.
In the map view, a point is displayed as a dot with a number. The straight line represents
the direction you are facing.
To set the geographic location
1
Tap the Point 1, Point 2 and Point 3 on the map. Make sure to set three location
points so that the straight lines started from the point can create three intersec-
tions.
2
Tap each point and use the Degree bar or button to change degrees.
Make sure you set three location points so that the straight lines started from the
point and can create three intersections.
3
Tap the GNSS icon to automatically get the selected point's location information.
The instrument displays the latitude and longitude information of the signal
received by the GNSS antenna. This function is only available when the GNSS
antenna is connected.
4
Tap the Latitude and Longitude icon and enter the value using the on-screen
keyboard to manually define a position.
The input values are in decimal degrees.
5
Tap the Apply button.
Setting azimuth
There are three methods available for setting azimuth:
Page 48
SPA06MA-O User's Guide
22145360, R005
April 2021
Advertisement
Table of Contents
