Table of Contents
Advertisement
Chapter 8 Using NSA Signal Analyzer
Conducting OTA measurements
3
If you select LTE, do the following step:
a
b
c
d
e
f
g
h
i
j
4
Once the carrier setup is done, the carrier setup information appears on the top
left screen.
Figure 129
LTE carrier) measurement.
Figure 129 NSA scanner with LTE and NR carrier measurement.
Page 278
Select Center Frequency to set the center frequency using the on-screen
keyboard.
Select Channel Standard to set the channel standard for the selected carrier
using the on-screen keyboard.
If the MIMO is set to 2x2, the antenna ports 2 and 3 are disabled.
Select Channel Number to set the channel number for the selected index
using the on-screen keyboard.
Tap External Offset and input the value using the on-screen keyboard and
tap to switch the external offset to On (green) or Off (gray) as desired.
Tap Attenuation and input the value using the on-screen keyboard if you
want to set it manually (Manual). Or tap it to set Auto.
Tap to switch Preamp 1, 2, and Auto to On (green) or Off (gray).
Tap to switch PCI (Physical Cell ID) to Manual (number) or Auto and input a
value in the number box from 0 to 1007 using the on-screen keyboard.
Tap to switch LTE Mode to TDD or FDD.
Tap Bandwidth and input the value using the on-screen keyboard.
Tap to switch Cyclic Prefix to Extended or Normal.
shows an example of NSA scanner with LTE and NR carrier (When tapped
NOTE
If you want to see the constellation information, tap and select the carrier
number that you want to check. If tapped, the carrier information will be
highlighted in purple and constellation information will appear.
SPA06MA-O User's Guide
22145360, R005
April 2021
Advertisement
Table of Contents
