Introduction; Selecting Mode And Measure - Viavi SPA06MA-O R005 User Manual

Table of Contents

Advertisement

Chapter 9 Using 5G DSS Signal Analyzer

Introduction

Introduction
Dynamic Spectrum Sharing (DSS) Signal Analyzer allows the deployment of both 4G
LTE and 5G NR in the same frequency band and dynamically allocates spectrum
resources between the two technologies based on user demand.
The module provides following measurements for 5G DSS analysis:
Spectrum Analysis
RF Analysis
Power vs Time
Modulation Analysis
OTA Analysis

Selecting mode and measure

The following procedure describes how to start measurement.
To select mode and measure
1
Tap 5G DSS Signal Analyzer on the MODE panel.
Page 290
Spectrum
Channel Power
Occupied Bandwidth
Spectrum Emission Mask
ACLR
Multi-ACLR
Spurious Emissions
Power vs Time (Frame)
Power vs Time (Slot)
Constellation
Channel Mapper
Control Channel
Subframe
Frame
Time Alignment Error
OTA Channel Scanner
OTA ID Scanner
OTA Multipath Profile
OTA Control Channel
OTA Route Map
Freq/Time/Power Variation
SPA06MA-O User's Guide
22145360, R005
April 2021

Advertisement

Table of Contents
loading

This manual is also suitable for:

Spa06ma-oSpa06ma

Table of Contents