Table of Contents
Advertisement
5
Once you have loaded the map, you can also control the map using the following
icons on the map.
Table 13 Map icons
Icon
To set measurement setup
Before starting the Route Map measurement, you need to set Spectrum measurements
displayed on the quick access and display tab. See
ments" on page 9
1
If required, connect a GNSS receiver to your instrument for outdoor mapping.
Indoor mapping does not necessarily need a GNSS antenna.
2
Tap the Setup (
3
Tap to switch the Plot Point to GPS, Position, or Time.
a
b
c
4
Tap to switch Plot Item to RSSI or ACP.
April 2021
Description
Tap to go to your current location on the map. Once tapped,
a purple icon appears on the map, indicating your current
location.
Tap to switch to the full screen map view.
Tap to zoom in on the map.
Tap to zoom out on the map.
Tap and select the area that you want to expand.
for more information.
) icon on the side bar.
To collect data/plot points automatically as you move around in a vehicle or
outside, select GPS, then tap to switch the Screen Mode between Map and
Full. With the Map setting, you can view only the collected points that can be
seen within the boundary of the loaded map. With the Full setting, you can
view all the collected points of the route without the loaded map.
To collect data/plot points manually in an indoor layout without a GNSS
antenna, select Position.
To collect data/plot points based on time, select Time.
SPA06MA-O User's Guide
"Configuring spectrum measure-
22145360, R005
Chapter 2 Using Spectrum Analyzer
Page 37
Utility
Advertisement
Table of Contents
