Table of Contents
Advertisement
Chapter 9 Using 5G DSS Signal Analyzer
Conducting RF measurements
Setting measure setup
After configuring the spectrum measurement in
on page
measurement settings can be saved and recalled as a file by selecting File Type as
Setup and load the file onto the instrument using the Save/Load icons on the side bar.
To set measure setup
1
Tap the Setup (
2
Tap Bandwidth from the following choices: 5 MHz, 10 MHz, 15 MHz, or 20 MHz.
3
Tap to switch Signal Tech Type to TDD or FDD.
4
Tap Menu > BW/AVG > Average to set the number of measurements to be aver-
aged using the on-screen keyboard.
The input value range is from 1 to 100.
To set the limit
1
Tap Menu > Limit.
2
Tap to switch the Test Limits to On or Off to enable or disable Pass/Fail indica-
tion. The result table color for Pass is green, and the result table color for Fail is
red.
3
Optional. Tap the Save icon on the side bar and select the save option from the
choices available for your measurement mode.
Figure 141
Figure 141 5G DSS Multi-ACLR measurement
Page 298
9, you can set the measure setup to continue your measurement. The
) icon in the side bar.
shows an example of Multi-ACLR measurement.
NOTE
You can set the Lowest Ref. Frequency and Highest Ref. Frequency by tap-
ping the rectangle with value using the on-screen keyboard.
SPA06MA-O User's Guide
"Configuring spectrum measurements"
22145360, R005
April 2021
Advertisement
Table of Contents
