Table of Contents
Advertisement
To log data
1
Follow step 1 to 3 in Setting measure setup.
2
Tap the Testing button on the right panel of the map to start plotting on the map.
When you select a point on the map, a marker appears and the Information
window appears on the right panel.
3
Tap the Stop (
4
Tap the Pause button (
plotted.
5
If you start test and select Setup > Map Config > Plot Point > Position, you can
undo by tapping the Testing button.
6
If you select the Stop button, the Plot Stop pop-up window appears, then tap Yes.
7
Tap Yes when the Save pop-up window appears and the logging file to your USB.
Viewing the logging data
To view the logging data
1
Load the saved logging file using the Load (
the file extension is.gomv.
2
If the PCI is set to Auto, the point on the map appears with a color representing
the largest S-SS-RSRP value. When you select a point on the map, a marker
appears and the Information window appears on the right panel.
3
Set the PCI to Manual and tap the Select button.
The Select PCI window appears.
4
Select PCI on the left and then the corresponding Beam Index appeared on the
right.
5
Tap the Apply button.
The point color of the map changes to the corresponding SS-RSRP value, and if
there is no detected Beam Index, the point will be hidden.
Importing cellsite DB
You can import the site DB by creating the 5G site information form.
To import cellsite DB
1
Create the 5G site information with an excel file as below.
April 2021
) button to stop plotting.
NOTE
When you load the result file, a pop-up message asking whether you want to
load data only or data with map appears. If the current screen does not display
all the loaded data, the screen mode will be automatically changed to Full.
SPA06MA-O User's Guide
) to pause plotting, then the GPS point cannot be
22145360, R005
Chapter 7 Using 5G NR Signal Analyzer
Conducting OTA measurement
) icon on the side bar. Make sure
Page 225
Advertisement
Table of Contents
