Table of Contents
Advertisement
Chapter 2 Using Spectrum Analyzer
Setting limit
Figure 5
Setting limit
A limit value can be set to alert you that the measured value exceeds the value that is
specified. If the span is selected as Zero Span, the line is not displayed.
Table 10
Table 10 Limit functions
Parameter
Display Line
Display Line Mode
On/Off
Multi Segment
Line
To configure Multi Segment Line
1
Tap Menu > Limit
2
Tap Multi Segment Line.
Page 18
Trace 1 and Trace 2 measurement results
describes each function.
Description
Tap to set values for the reference line using the on-screen
keyboard.
Access: Menu > Limit > Display Line
Tap to set the Display Line Mode to On or Off to display or
dismiss the reference line. The inactive vertical move bar on
the left edge with straight line appears across the screen to
be used as a visual reference only. To adjust the display
line, tap and drag the move bar up or down. The vertical
move bar then becomes activated.
If there is no touch operation for 2 seconds, the move bar
becomes inactive again. The display line does not indicate
Pass/Fail.
Access: Menu > Limit > Display Line Mode On/Off
Tap Multi Segment Line for Pass/Fail indication.
Access: Menu > Limit > Multi Segment Line
SPA06MA-O User's Guide
22145360, R005
April 2021
Advertisement
Table of Contents
