Table of Contents
Advertisement
Chapter 11 Using EMF Analyzer
Conducting signal measurement
b
c
d
e
f
g
h
i
Page 386
If you want to set Auto Scale and Preamp to Auto. You can set it to On.
Tap Dwell Time to specify the amount of measurement time that you want
the instrument to stay for on each axis and input the value from 1 to 60
(second) using the on-screen keyboard.
Tap Measurement Time to specify the amount of measurement time that you
want the instrument to stay for on all three axes in order to display current
and accumulated EMF power and set this up to 60 minutes using the on-
screen keyboard.
NOTE
If you set the measurement time, the count which means the number of EMF
measurements on the right panel of the measurement screen is changed cor-
responding to the measurement time you have set.
Tap to switch Axis to Manual or Auto.
If you set it to Manual, Axis setting is available and if you set it to Auto, Axis
setting is unavailable.
Manual: When using isotropic EMF antenna, you can manually set x, y,
-
and z axis. You can set Manual as a diagnosis mode whether you can
receive correct signal based on each axis: X, Y, or Z.
-
Auto: Each axis of antenna is automatically changed and measured.
When selected as Manual, tap Axis and select from: X, Y, or Z.
Tap UL/DL Config and select Simple (default).
Tap UL (%) and input the value using the on-screen keyboard.
Tap DL (%) and input the value using the on-screen keyboard.
Tap Move to RtSA to view the real-time spectrum measurement mode.
SPA06MA-O User's Guide
22145360, R005
April 2021
Advertisement
Table of Contents
