Table of Contents
Advertisement
3
Tap Mask Type and select the type from the following choices: Wide Area BS A,
Wide Area BS B, Local Area BS, Home BS.
4
Tap Subframe Number and input the value from 0 to 9 using the on-screen
keyboard.
5
Optional. Tap to switch Physical Cell ID to Manual or Auto.
–
–
To set limit
1
Tap Menu > Limit.
2
Tap to switch the Test Limits to On or Off to enable or disable Pass/Fail indica-
tion.
The result table color for Pass is green, and the result table color for Fail is red.
3
Optional: Tap the Save hot key on the side bar and select the save option from the
choices available for your measurement mode.
Figure 71
ment.
Figure 71 LTE/LTE-A TDD spectrum emission mask measurement
April 2021
Auto lets the instrument detect the Physical Cell ID for the LTE signal auto-
matically
Manual sets a specific Physical Cell ID for the LTE signal manually in order to
speed up the synchronization with a BTS.
shows an example of LTE/LTE-A TDD spectrum emission mask measure-
NOTE
If Lower Peak or Upper Peak indicates Fail, the mask line becomes red.
If the Trace View is set to Off, the Reference Power, Lower Peak, and Upper
Peak is not shown. If the Trace View is set to On and the Trace Type is
selected other than Clear Write, the Reference Power, Lower Peak, and Upper
Peak is shown with value and
SPA06MA-O User's Guide
"*"
at the end of the value.
22145360, R005
Chapter 6 Using LTE/LTE-A TDD Analyzer
Conducting RF measurement
Page 141
Advertisement
Table of Contents
