Table of Contents
Advertisement
Chapter 10 Using RFoCPRI Analyzer
Configuring test parameters
3
Choose one of the following options: 100 kHz, 30 kHz, 10 kHz, or 7.5 kHz.
–
–
4
Tap VBW to set the video bandwidth and choose one of the following options: 100
kHz, 30 kHz, 10 kHz or 7.5 kHz.
Setting average
You can set the number of measurements to be averaged for the trace presentation in
the Spectrum and Spectrogram modes. A maximum of 100 times of averaging can be
set. When the averaging reaches your setting, a new measurement value replaces the
measurement value in sequence from the earliest.
To set average
1
Tap Menu > Sweep.
2
Select the desired sweep run mode by tapping the Sweep Mode between Single
and Continue
–
–
3
Optional: In Single Mode, tap Sweep Once to get a new measurement.
Setting sweep mode
Different sweep settings are available for RFoCPRI Spectrum and Spectrogram
measurement modes for better measurement, including the sweep run mode (Single,
Continue).
To set sweep mode
1
Tap Menu > Sweep.
2
Select the desired sweep run by tapping the Sweep Mode between Single and
Continue:
–
–
3
Optional: In Single mode, tap Sweep Once to get a new measurement.
Page 360
For signal bandwidths 1.4 MHz and 3 MHz: RBW from 1 kHz to 30 kHz
For signal bandwidths 5 MHz, 10 MHz, 15 MHz, and 20 MHz: RBW from 1
kHz to 100 kHz
Single: The instrument performs a single sweep and waits for further entries.
Continue (default): The instrument is continually measuring and updating
results.
Single: The instrument performs a single sweep and waits for further entries.
Continue (default): The Instrument is continuously measuring and updating
the result.
SPA06MA-O User's Guide
22145360, R005
April 2021
Advertisement
Table of Contents
