Multi-Aclr - Viavi SPA06MA-O R005 User Manual

Setting measure setup
After configuring the spectrum measurement in
on page
To set measure setup
1 Tap the Setup (
2 Tap Bandwidth and select the value from the following choices: 1.4 MHz, 3 MHz,
5 MHz, 10 MHz, 15 MHz, or 20 MHz.
You can also tap the rectangle with value,(
the chart screen and input the value using the on-screen keyboard.
To set limit
1 Tap Menu > Limit.
2 Tap to switch the Test Limits to On or Off to enable or disable Pass/Fail indica-
tion.
The result table color for Pass is green, and the result table color for Fail is red.
3 Optional: Tap the Save hot key on the side bar and select the save option from the
choices available for your measurement.
Figure 42
Figure 42 LTE/LTE-A FDD ACLR measurement

Multi-ACLR

The Multi-ACLR measurement is used to perform multi-channel ACLR measurements
with as many channels as possible. It helps you to measure ACLR in multi-channel
transmitting Base Station environment.
Setting measure setup
After configuring the spectrum measurement in
on page
April 2021
9, you can set the measure setup to continue your measurement.
) icon in the side bar.
shows an example of LTE/LTE-A FDD ACLR measurement.
9, you can set the measure setup to continue your measurement.
SPA06MA-O User's Guide
"Configuring spectrum measurements"
"Configuring spectrum measurements"
22145360, R005
Chapter 5 Using LTE/LTE-A FDD Analyzer
Conducting RF measurement
) under
Page 91