Table of Contents
Advertisement
8
Tap SSB Auto Search Mode and do the following steps:
a
b
9
Tap SSB Periodicity and select the options from 5 ms, 10 ms, 20 ms, 40 ms, 80
ms, 160 ms. The SS burst period (SSB periodicity) is defined by each base
station and network configurable. 20 ms is the default for the initial cell selection.
10 Tap to switch PCI (Physical Cell ID) to Manual or Auto.
11 Tap PCI and input a value from 0 to 1007 using the on-screen keyboard. The PCI
switches to Manual.
12 Tap to switch Sorting Type to PCI or RSRP.
If you select PCI, it shows PCI information on the measurement screen and if you
select RSRP, it shows S-SS RSPR power on the measurement screen. You can
also set it in the Detected ID List table.
Table 40 Setup per operating frequency
Operating
frequency
< 3 GHz
(FR1)
< 3 GHz
(FR1)
< 3 GHz
(FR1)
3 to 6 GHz
(FR1)
3 to 6 GHz
(FR1)
April 2021
Tap Auto Preamp/Atten and switch SSB Auto Search to Start to set
preamp and attenuation automatically.
Tap Manual and switch SSB Auto Search to Start for manually setting
based on your need.
NOTE
If you tap SSB Auto Search to Start, the searching progress screen appears to
let you know the status of searching.
You can tap SSB Auto Search to Stop to stop searching.
NOTE
You can go to Menu > Frequency > Center Frequency List to add frequently
used center frequency using the Add button in the Frequency List or to delete
the selected frequency using the Delete button. You can also apply one of the
default frequencies in the Frequency List by tapping the Apply button.
L
4
4
4
8
8
SPA06MA-O User's Guide
Case
A
{2,8} +14*n
B
{4,8,16,20}
+28*n
C
{2,8} +14*n
A
{2,8} +14*n
B
{4,8,16,20}
+28*n
22145360, R005
Chapter 7 Using 5G NR Signal Analyzer
Conducting OTA measurement
Slots in a
SCS
burst period
15 kHz
5 (1 ms)
30 kHz
10 (0.5 ms)
30 kHz
10 (0.5 ms)
15 kHz
5 (1 ms)
30 kHz
10 (0.5 ms)
Page 213
Advertisement
Table of Contents
