Table of Contents
Advertisement
Table 43 Map control icons
Icon
The left-most cell-site icon is activated when you import the cell-site information file.
To set measurement setup
Before starting the Route Map measurement, you need to set Spectrum measurements
displayed on the quick access and display tab. See
ments" on page 9
1
If required, connect a GNSS receiver to your instrument for outdoor mapping.
Indoor mapping does not necessarily need a GNSS antenna.
2
Tap the Setup (
3
Tap Map Config to configure the map setting.
a
b
c
4
Tap Bandwidth/SSB SCS and select the Setting in the pop-up window based on
your need. SSB is abbreviation for Synchronization Signal Block or SS Block and
it refers to Synchronization PBCH block since the synchronization signal and
April 2021
Description
Tap to zoom in the map.
Tap to zoom out the map.
Tap and select the area where you want to expand.
for more information.
) icon on the side bar.
Tap to switch the Plot Point to GPS, Position, or Time.
-
To collect data/plot points automatically as you move around in a vehicle
or outside, select GPS.
-
To collect data/plot points manually in an indoor layout without a GNSS
antenna, select Position.
-
To collect data/plot points based on time, select Time.
Tap to switch Plot Item to P-SS RSRP, S-SS RSRP, S-SS RSRQ or S-SS
SINR.
Tap to switch the Screen Mode between Map and Full.
-
With the Map setting, you can view only the collected points that can be
seen within the boundary of the loaded map.
-
With the Full setting, you can view all the collected points of the route
without the loaded map
SPA06MA-O User's Guide
"Configuring spectrum measure-
22145360, R005
Chapter 7 Using 5G NR Signal Analyzer
Conducting OTA measurement
Page 221
Advertisement
Table of Contents
